Posted by
FSP Europe Team
on 23/02/2021
6.9. UPS Maintenance
A UPS is used as the backup power supply when the mains fails, therefore, the readiness of it is critical. [...]
Read morePosted by
FSP Europe Team
on 16/02/2021
1.5 UPS Operation Setting – 6K/10K
In this page we will introduce the hardware interface & panel setting options of our entry 6/10K UPS, [...]
Read morePosted by
FSP Europe Team
on 08/02/2021
6.6. How do I select the battery cabinet when using long run UPS?
Three parameters need to be considered when selecting battery: voltage, charging current and backup time. [...]
Read morePosted by
FSP Europe Team
on 08/02/2021
6.3. What is Emergency power off function, when and how to use it?
That’s EPO. Once you understand it, you will know when and how to use it directly. As we know, UPS is [...]
Read morePosted by
FSP Europe Team
on 08/02/2021
6.2. How to choose a UPS for laser printer and copy machines?
Basically we do not suggest inductance load, such as the devices with motor and the devices with high peak [...]
Read morePosted by
FSP Europe Team
on 08/02/2021
5.4. Backup time is too short
Two factors impact the backup time, the load power and battery real capacity. If the load is different from [...]
Read morePosted by
FSP Europe Team
on 08/02/2021
5.5. When battery is dead, will UPS still work in standby mode?
No for offline and line interactive UPS 🡪 when AC comes back after black out, the UPS initializes and will [...]
Read morePosted by
FSP Europe Team
on 08/02/2021
5.6. Why cannot my small-power-consumption device get power from the UPS when mains is off?
When selecting UPS, we consider two key factors, the output power and backup time, to make sure the UPS has [...]
Read morePosted by
FSP Europe Team
on 08/02/2021
5.2. Measured UPS output voltage is lower than expectation
There are three tools to measure AC voltage, true RMS, average sensing digital meters and oscilloscope. [...]
Read more